Upgrade your vehicle's TPMS system with this set of 1 pre-programmed tyre pressure monitoring sensor. This OE-replacement sensor provides accurate pressure readings and keeps your dashboard TPMS warnings working as intended.

OE part number(s): F2GZ1A189AB

Radio frequency: 315 MHz

Compatibility

• Ford F-150
• Ford Explorer
• Ford Mustang

Installation & programming

1. Remove the tyre, deflate it fully and unbolt the old TPMS sensor from the wheel.
2. Install the new sensor on the rim and tighten to the manufacturer's specified torque.
3. Reinflate the tyre, balance the wheel and remount on the vehicle.
4. Drive for several minutes at 15 mph (24 km/h) or more to allow the sensor to self-register.
5. If the ECU does not recognise the sensor, run the vehicle TPMS relearn procedure.
6. As a last resort, use an OBD-II TPMS programming tool to write the sensor ID to the ECU.
7. If OBD programming fails, repeat steps or consult a professional to verify correct ID transmission.

Troubleshooting

• If the tyre-pressure warning lamp remains on, confirm correct tyre pressures and adjust.
• Check sensor torque and sealing washer to prevent air leaks.
• Verify OE part number and radio frequency (315 MHz) match original sensor.
• Clear stored TPMS faults in the ECU before test-driving.
• Swap wheel positions to see if the fault follows the sensor (helps identify defective unit).

Notes

• Sensor is supplied pre-programmed and typically self-registers after installation.
• 1 year warranty for manufacturing faults and battery failure.
• Package contains: 1 x pre-programmed TPMS sensor (315 MHz).