Refresh the valve stems on your existing TPMS sensors with this set of four highquality replacement kits. Each kit includes new stems and seals to restore an airtight seal and keep your tyre pressure monitoring system working correctly. It is listed for the Dodge Avenger, Caliber and Challenger.

Features

• Quantity: 4 repair kits
• Silver metal valve stem with a black rubber seal and a plastic dust cap
• Each kit includes the stem, nut, seal, washer and cap
• Overall height 5.4cm, and 1.7cm across the sensor head
• Refreshes the valve on an existing TPMS sensor. The sensor electronics are not included

Compatibility

• Dodge Avenger
• Dodge Caliber
• Dodge Challenger
• CMAX 20142016
• Ecosport (B515) 2012 onwards
• Escape (C520) 20122017
• Fiesta (B479) 2017 onwards
• Tourneo Connect 2014 onwards
• Transit Custom 2013 onwards
• F150 2015 onwards
• Ka+ 2016 onwards
• Mustang 2004 onwards
• BMax 2014 onwards
• Edge 2014 onwards
• Expedition 2017 onwards

Installation

1. Remove the wheel and deflate the tyre completely.
2. Take off the old TPMS valve stem, seal and hardware.
3. Fit the new metal stem, seal, nut and cap from this kit and tighten them securely.
4. Reinflate the tyre and check for leaks before refitting the wheel.
5. Disassemble the old TPMS valve stem and remove the Oring and hardware.
6. Install the new valve stem, clip and seal from this kit and tighten securely.

Notes

• Compare the valve on your original sensor before ordering.
• This kit renews the valve stem only. It is not a complete TPMS sensor.
• Includes a 1 year warranty covering manufacturing defects on the replacement components.
• This repair kit refreshes the valve stems on your existing TPMS sensors.